I will be making some custom made jetbridges.
I will use 8mm square tubes and 7.2mm square tubes for the closest part of the jetbridge near the Terminal.
Materials that I'll be using...
Dont laugh, this is only a prototype ...
C-rex’s Jetbridge Prototype
1. "Candlelight" cut about 1 inch (as base)
2. 8mm Square tube
3. 6.4mm Square tube
4. 1.2mm cylinder tube (for joints)
5. Wooden sticks (IDK what for?)
I have already jumpstarted and forgot to the the first steps in the making..
This Jetbridge is in retracted mode.
Here you see it extended mode...
Since I was that stupid to forget the glue, I had to improvise..
I was actually shopping for new 1:200's and some 1:400's...
This is where number 4, the cylinder tube comes on the list..
It will be used to lock joints as you can see just at start of the Jetbridge..
More to come, and I will update with process photos.
I will use 8mm square tubes and 7.2mm square tubes for the closest part of the jetbridge near the Terminal.
Materials that I'll be using...
Dont laugh, this is only a prototype ...
C-rex’s Jetbridge Prototype
1. "Candlelight" cut about 1 inch (as base)
2. 8mm Square tube
3. 6.4mm Square tube
4. 1.2mm cylinder tube (for joints)
5. Wooden sticks (IDK what for?)
I have already jumpstarted and forgot to the the first steps in the making..
This Jetbridge is in retracted mode.
Here you see it extended mode...
Since I was that stupid to forget the glue, I had to improvise..
I was actually shopping for new 1:200's and some 1:400's...
This is where number 4, the cylinder tube comes on the list..
It will be used to lock joints as you can see just at start of the Jetbridge..
More to come, and I will update with process photos.
Comment