Steve Worner - prescreening request / editing advice

[steveworner]

Thank you.

Can I get an opinion on this F100 please?

[dlowwa]

Thank you,

Can I get an opinion on this QF 787? I've gone for an 'oil painting' look...

A bit dark, but may be acceptable as-is.

[steveworner]

Thank you,

Can I get an opinion on this QF 787? I've gone for an 'oil painting' look...

[dlowwa]

Thank you, I won't persist with that one. Could I get an opinion on this 787? A new kind of shot for me.

Would be ok for me.

[steveworner]

Thank you, I won't persist with that one. Could I get an opinion on this 787? A new kind of shot for me.

[dlowwa]

Definitely a reflection! you'll see it's also on the leading edge of the left wing.

I'll trust you that it's a reflection though my brain can't process exactly how that is

Since it's visible on the rear of the fuselage behind the wing as well, decent chance it will be seen as a bad edit.

[steveworner]

Definitely a reflection! you'll see it's also on the leading edge of the left wing.

[dlowwa]

Thank you,

Can I get an opinion on this bizjet please?

Is that white line along the bottom of the fuselage due to a reflection/paint or bad edit?

[steveworner]

Thank you,

Can I get an opinion on this bizjet please?

[dlowwa]

Thank you,

Can I get an opinion on these images? as you'll detect, they were taken in the late afternoon, though I've wound back the 'warm' sunlight on them.

Quality's not quite there for 1920pix on the last two, but I think they should be ok at a lower resolution.

[steveworner]

Thank you,

Can I get an opinion on these images? as you'll detect, they were taken in the late afternoon, though I've wound back the 'warm' sunlight on them.

[dlowwa]

Thank you - would this version make the cut?

Other than the dust spots and slight editing halos, it would be ok for me.

[steveworner]

Thank you - would this version make the cut?

[dlowwa]

Thank you.

Does the pic below have JP potential, realising that it does not show the entire airframe?

Very likely to be rejected for cut off.

[steveworner]

Thank you.

Does the pic below have JP potential, realising that it does not show the entire airframe?