Originally posted by HernandoJose
View Post
Announcement
Collapse
No announcement yet.
HernandoJose - Prescreening request/Editing advice
Collapse
X
-
-
Hello, I received this rejection:
I've attached a 100% crop, the nose is a bit soft, but i don't see much heat distortion.
Regards!
Leave a comment:
-
Originally posted by dlowwa View Post
Heat haze is not noticeable. I've accepted the image.
I also wish some help on another rejection:
I see that the white of the fuselage is close to the right edge in the histogram but I didn't burn the whites in edition.
I also don't understand what category is wrong or missing.
I've re edited the image, but now i have some doubts if is underexposed:
Thanks in advance!
Leave a comment:
-
Not a screener but the heat distortion is available to me so will be rejected
Leave a comment:
-
Hello, I'd like some help on this rejection:
The heat distortion is minimum, is too much for 1920px?
This is a 100% crop:
Regards.
Leave a comment:
-
Originally posted by HernandoJose View PostHello, I wish some help on the following rejections:
Looking again I see excess of yellow and green tint. Is now better?
The previous Temp/Hue was 5500/10
Both were shooted in similar conditions, the sun had just set.
Why "Too much or too little contrast"? bad light?
Can they have any chance?
Thanks in advance!
2-3. lack of direct light on aircraft. not terrible, but difficult to improve.
Leave a comment:
-
Hello, I wish some help on the following rejections:
Looking again I see excess of yellow and green tint. Is now better?
The previous Temp/Hue was 5500/10
Both were shooted in similar conditions, the sun had just set.
Why "Too much or too little contrast"? bad light?
Can they have any chance?
Thanks in advance!
Leave a comment:
-
Hello, the stair is enough obstruction to be rejected or it could be an exception? Thanks in advance!
Leave a comment:
-
Hello, i'd like some preescreen about this image, especially if could be rejected due to bad motive, because of the car's plate. Should I blur it?
Thanks in advance!
Leave a comment:
Leave a comment: