MarkLawrence - Editing Advice

[MarkLawrence]

Still struggling with the new camera and settings and editing - please can screeners check the attached.

[dlowwa]

Still struggling with the new camera and settings and editing - please can screeners check the attached.
[ATTACH=CONFIG]17853[/ATTACH]

There is a cyan/green cast and it is suffering from compression.

[MarkLawrence]

Thanks Dana - I edited a different one in the set - applied some different settings - any better?

[MarkLawrence]

And also this one if possible.

[dlowwa]

Better yes. Still a slight cyan cast to both, but it's not too strong so they may be acceptable as they are.

[MarkLawrence]

Thanks very much Dana!!!

[MarkLawrence]

Would this class as back lit?

[LX-A343]

Would this class as back lit?

[ATTACH=CONFIG]17894[/ATTACH]

Unfortunately yes.

[MarkLawrence]

Darn it - my first B39M - but - understandable - was taking a flyer Thanks!!

[MarkLawrence]

Is this too close a crop or due to the uniqueness of the detail, would this be acceptable?

[dlowwa]

Is this too close a crop or due to the uniqueness of the detail, would this be acceptable?

[ATTACH=CONFIG]17917[/ATTACH]

Close up angels like that are ok, but the crop on the right is a bit awkward. Borderline contrast as well.

[MarkLawrence]

Thanks Dana - I have quite a few available to work on - just wanted to make sure the crop was okay.

[MarkLawrence]

This was rejected for soft before and I have adjusted the sharpening - is it acceptable now?

[LX-A343]

This was rejected for soft before and I have adjusted the sharpening - is it acceptable now?

[ATTACH=CONFIG]18370[/ATTACH]

Borderline. In my opinion, there is too much heat haze, which makes the aircraft look soft.

[MarkLawrence]

Gerardo - just a question - can the heat haze be confused for the exhaust gases from the engines? Just wondering....