Announcement

Collapse
No announcement yet.

cwk6888 - Editing Advice

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Originally posted by cwk6888 View Post
    [ATTACH=CONFIG]16627[/ATTACH]

    Please pre-screen. Is the image considered backlit?
    Technically yes, but might have a chance given the angle and light. Be careful to avoid any editing halos from boosting the shadows too much.

    Comment


    • #32
      Click image for larger version

Name:	DSC_3465.jpg
Views:	1
Size:	1.53 MB
ID:	1029114

      Is the crop acceptable? Is it correct to just use the WestJet registration and no need to select "Airport Overview" category? Thanks!

      Comment


      • #33
        Originally posted by cwk6888 View Post
        [ATTACH=CONFIG]17103[/ATTACH]

        Is the crop acceptable? Is it correct to just use the WestJet registration and no need to select "Airport Overview" category? Thanks!
        Borderline case; would be ok for me, but up to the discretion of whoever ends up screening it. This does not qualify as Airport Overview.

        Comment


        • #34
          The following photo was rejected for bad processing:

          https://www.jetphotos.com/viewqueued_b.php?id=6732330

          Would like to know what the problem is so that I don't make the same mistake again. Thanks in advance.

          Comment


          • #35
            Originally posted by cwk6888 View Post
            The following photo was rejected for bad processing:

            https://www.jetphotos.com/viewqueued_b.php?id=6732330

            Would like to know what the problem is so that I don't make the same mistake again. Thanks in advance.
            Don't see anything wrong with the processing.

            Comment


            • #36
              The following photo was rejected for undersharpened:

              https://www.jetphotos.com/viewqueued_b.php?id=6984956


              The front part of the fuselage looks fine to me. However, the rear portion and the tail are a bit blurry. Was it caused by the engine exhaust or other reason?

              Comment


              • #37
                Originally posted by cwk6888 View Post
                The following photo was rejected for undersharpened:

                https://www.jetphotos.com/viewqueued_b.php?id=6984956


                The front part of the fuselage looks fine to me. However, the rear portion and the tail are a bit blurry. Was it caused by the engine exhaust or other reason?
                Front is sharp, but tail is very soft, almost blurry. Look at how soft the FedEX logo on the tail is. That's not cause by engine exhaust.

                Comment


                • #38
                  Click image for larger version

Name:	DSC_1880.jpg
Views:	2
Size:	993.5 KB
ID:	1032409

                  Is decal considered to be special scheme? Thanks.

                  Comment


                  • #39
                    Originally posted by cwk6888 View Post
                    [ATTACH=CONFIG]21159[/ATTACH]

                    Is decal considered to be special scheme? Thanks.
                    Yes.

                    Comment


                    • #40
                      Need advice on how to center the airplane of the following rejected photo:

                      https://www.jetphotos.com/viewqueued_b.php?id=7069487

                      The "Center" tool crosshair is at the center of the fuselage, but the airplane appears to be high on the frame due to the angle of the photo. What would be the proper reference point? Thanks in advance.

                      Comment


                      • #41
                        Originally posted by cwk6888 View Post
                        Need advice on how to center the airplane of the following rejected photo:

                        https://www.jetphotos.com/viewqueued_b.php?id=7069487

                        The "Center" tool crosshair is at the center of the fuselage, but the airplane appears to be high on the frame due to the angle of the photo. What would be the proper reference point? Thanks in advance.
                        Aircraft is a little too high. You've centered the tail. If you are going to use the centering tool, center the middle of the fuselage.

                        Comment


                        • #42
                          Originally posted by dlowwa View Post
                          Aircraft is a little too high. You've centered the tail. If you are going to use the centering tool, center the middle of the fuselage.
                          Thanks Dana. Is this one better?

                          Click image for larger version

Name:	DSC_1941.jpg
Views:	1
Size:	535.9 KB
ID:	1032556

                          Comment


                          • #43
                            Originally posted by cwk6888 View Post
                            Thanks Dana. Is this one better?

                            [ATTACH=CONFIG]21331[/ATTACH]
                            Centering would be acceptable to me.

                            Comment


                            • #44
                              The following photo was rejected for Obstructing Objects / Foreground Clutter:

                              https://www.jetphotos.com/viewqueued_b.php?id=7085989


                              Would like to know what the objects/clutter are. Also anything I can do about the contrast? Thanks.

                              Comment


                              • #45
                                The screener had left you a message

                                Now we have never rejected such case for obstruction so it was a wrong vote by our screeners. I've now added your shot
                                http://www.jetphotos.com/photo/9215071

                                Regards
                                Alex

                                Comment

                                Working...
                                X