[Editing advice] Pre-screening

[dlowwa]

Hi. I have one photo for pre-screen.

Image is soft/blurry toward the right edge.

[Walker_Xu]

Hi. I have one photo for pre-screen.

[dlowwa]

Hi
I think these two photos are good enough to accept, Horizontal are both leveled.
https://www.jetphotos.com/viewqueued_b.php?id=7578933
https://www.jetphotos.com/viewqueued_b.php?id=7578946
Thanks for the advice

Um, no. Verticals are all off, especially on the second one which is not even close to being level.

[Walker_Xu]

Hi
I think these two photos are good enough to accept, Horizontal are both leveled.
https://www.jetphotos.com/viewqueued_b.php?id=7578933
https://www.jetphotos.com/viewqueued_b.php?id=7578946
Thanks for the advice

[dlowwa]

[ATTACH=CONFIG]26431[/ATTACH][ATTACH=CONFIG]26432[/ATTACH]
Pre-screen please.

1. noisy, borderline soft
2. ok

[Walker_Xu]

Pre-screen please.

[Walker_Xu]

Not sure what's going on about this photo. The # of view is 0 since it was uploaded lol.
https://www.jetphotos.com/photo/9351318
Thanks for the help.

[dlowwa]

First two borderline soft/low contrast; yes third one looks like top of fuselage almost blown out.

[Walker_Xu]

Thanks for the pre-screen. Could you also pre-screen these two?
[ATTACH=CONFIG]25381[/ATTACH][ATTACH=CONFIG]25382[/ATTACH]

One more here! Struggle with the over-exposure at the nose.

[Walker_Xu]

Crop is acceptable, but looks somewhat compressed.

Thanks for the pre-screen. Could you also pre-screen these two?

[dlowwa]

Thanks guys, what about this one?
[ATTACH=CONFIG]25346[/ATTACH]

Crop is acceptable, but looks somewhat compressed.

[Walker_Xu]

Indeed, if you're going to crop the rotor, might as well crop it closer. Horizon also appears a bit off.

Thanks guys, what about this one?

[dlowwa]

Indeed, if you're going to crop the rotor, might as well crop it closer. Horizon also appears a bit off.

[CrosswindPhoto]

Crop it tighter and it should be ok.

[Walker_Xu]

Hello. Yesterday I got this helicopter in Montreal. It is a first registration in JP but I found that on piece of the airscrew is missing...(on the right side). Is it acceptable or not? Thank you.